Every point where the field was measured, shown where it sits on the accessory. Choose a setting when the test has more than one, then click or tap a layer in the stack to the left of the picture (above it on a phone). Hover over a point, or slide a finger across the points, to see its position and the field strength measured there. Every layer is colored on one scale, so a layer farther from the surface reads cooler. Pinch, or hold Ctrl and scroll, to zoom in.
Illustrative example: real Gauss Labs measurements of a Donut Coil, shown to illustrate what this coil type looks like. It is not a spec for a specific product. Setting 5 was scanned along all four axes; the other four settings were scanned along a single line out from the center, which is the usual bench protocol.
Loading the measured points.